Earthworks C30/C-W Choir MicrophoneChoir microphones have always presented a unique design and installation challenge – the traditional solution is to use an angle guide on the microphone’s lead to aim towards the performance venue. The problem with this approach is that either a very small microphone had to be used to keep aimable weight within practical limits – or locate the microphone’s electronics at some considerable distance from the element – inviting losses and noise. The ChoirMic™ Series solves all of these problems. Our hanging choir microphones provide pristine audio quality without spotlighting and more gain before feedback while picking up almost no sound from the rear of the microphones. They are ideal for miking choirs and orchestra or band in front of the choir.Frequency Response: 30Hz to 30kHz ±2dB at 12 inches (30.5cm)Polar Pattern: CardioidSensitivity: 10mV/Pa (-40dBV/Pa)Power Requirements: 48V Phantom, 10mAMax Acoustic Input: 145dB SPLOutput: XLR (pin 2+)Output Impedance: 100 balanced (50 each pins 2 & 3)Min Output Load: 600 between pins 2 & 3Noise: 22dB SPL equivalent (A weighted)Dimensions L x D: 324mm x 22mm (12.75 x .860 inches)Attached Cable: 30 feet (9.14m) Canare Star QuadWeight: .22 lb. (100g) microphone only1.2 lb (544.3g) microphone with 30 cable · 30kHz flat frequency response· No spotlighting· Uniform frequency response on or off axis· More gain before feedback· Picks up almost no sound from the rear of the microphone· Electronics housed in microphone· Prevents RFI· Mini-gooseneck allows quick and easy positioning· Comes with 30 foot balanced, twisted pair Canare cable· Custom cable lengths available· Does not come with XLR (order accessory C30-XLR for installed male XLR)